Posts for tag: air abrasion
Drilling teeth is an essential part of repairing and restoring the damage caused by tooth decay. For generations dentists have relied on the dental drill with its rotating burr to remove decayed and damaged tooth material.
But while the dental drill is effective it also has its disadvantages. In the process of removing decayed material it inadvertently removes healthy structure near the target material. It often requires anesthesia to deaden the work area. And its noise and vibration are often unsettling to patients.
There is a growing alternative, though: air abrasion, a technology that's been around since the mid-20th Century. But recent advances in controlling the dust created by using abrasion, as well as new tooth-colored bonding materials to replace tooth structure, have sparked new interest among dentists and patients alike.
Also known as particle abrasion, this drill alternative uses a pressurized stream of fine particles to remove decayed material. Using a hand wand a dentist can precisely aim the stream of particles (usually aluminum oxide) to the specific areas of decay or softened material that need to be removed. As a result, it removes only a fraction of healthy tooth structure compared to traditional drilling. Air abrasion has also proven effective for removing staining without harming enamel.
Air abrasion also eliminates the sound and vibration associated with dental drills, and may not always require local anesthesia. On the other hand, it does have some limitations. For one, it's not as effective with larger cavities or working around older fillings. The tooth or teeth to be worked on must be carefully isolated from the rest of the mouth to keep the patient from swallowing the abrasive particles. And without a high-volume suction pump and good isolation protocols, the particles can produce something of a “sandstorm” in the treatment room.
But as air abrasion continues to advance, we may see improvements in these limitations. In a future time, the traditional dental drill may go the way of the horse and buggy.
If you would like more information on air abrasion as an alternative to drilling, please contact us or schedule an appointment for a consultation. You can also learn more about this topic by reading the Dear Doctor magazine article “Air Abrasion Technology.”
For years preparing teeth for fillings or other restorations has required the use of a drill. Although quite effective in removing decayed structure and preparing the tooth for bonding, it usually requires a local anesthetic. That and the noise it generates can be unsettling for many patients.
In recent years, a different type of technique known as “air abrasion” has increased in popularity among dentists. Known also as “particle abrasion,” the technique uses a stream of fine particles to remove decayed tooth structure and is less invasive than the traditional drill. Although the technology has been around since the mid-20th Century, recent developments in suction pumps that remove much of the dust created have made it more practical. It also works well with new natural-looking bonding materials used for tooth structure replacement.
The fine particles — usually an abrasive substance like aluminum oxide — are rapidly discharged through a hand-held instrument using pressurized air aimed at affected tooth areas. Decayed teeth structure is softer than healthier tissue, which allows air abrasion to precisely remove decay while not damaging the other.
Besides removing decay or abrading the tooth for bonding, air abrasion can also be used to minimize stained areas on surface enamel and to clean blood, saliva or temporary cements from tooth surfaces during dental procedures. It’s also useful for smoothing out small defects in enamel or aiding in sealant applications.
It does, however, have a few limitations. It’s not as efficient as the traditional drill with larger cavities or for re-treating sites with metal (amalgam) fillings. Because of the fine texture of the abrasive particles, affected teeth need to be isolated within the mouth using a rubber dam or a silicone sheet. High-volume suction must be continually applied to capture the fine particles before the patient swallows them or it fills the procedure room with a fine cloud of material.
Still, while air abrasion technology is relatively new, it has clear advantages over the traditional drill in many procedures. As advances in the technology continue, air abrasion promises to offer a more comfortable and less invasive experience in dental treatment.